Today, I'd like to briefly introduce the installation method of windproof rolling shutter door, hoping to help you.

　　1.卷簾門在安裝大軸之前，先將固定方向的掛板安裝在卷軸上，然后將4-6片簾板安裝在掛板上，并卷在卷軸上的四川絲上。

　　1. Before installing the main shaft of the rolling shutter, first install the hanging plate with fixed direction on the rolling shaft, then install 4-6 pieces of the curtain plate on the hanging plate, and roll them on the Sichuan silk on the rolling shaft.

　　2.提升快門門軸,必須注意,設(shè)置一個特殊的命令,hermitage梯子,腳手架,手起重機必須經(jīng)過檢查,百葉窗安裝將覆蓋軸承和閥座的光學軸端孔的盤,對齊后軸承固定螺栓緊固。

　　2. Pay attention to the safety when lifting the shutter door shaft. Set a special command. Hermitage ladder, scaffold and crane must be inspected. The shutter installation will cover the plate of the optical shaft end hole of the bearing and the valve seat. After alignment, the bearing fixing bolts shall be fastened.

　　3.卷筒裝好后，可以左右移動卷筒調(diào)整其位置，同時用水平尺和水平管檢查卷筒的水平。

　　3. After the drum is installed, it can move the drum left and right to adjust its position, and check the level of the drum with a level ruler and a horizontal pipe.

　　4.吊裝卷筒時要特別注意不要損壞卷在軸上的簾板，用鋼絲繩捆扎時要墊好簾板。

　　4. Pay special attention not to damage the curtain plate rolled on the shaft when hoisting the drum, and pad the curtain plate when binding with steel wire rope.

　　看了濟南卷簾門廠家上面的介紹，相信大家對它有了一定的了解。如果您有任何疑問，歡迎來電咨詢，我們竭誠為您服務(wù)。

　　After reading the introduction of Jinan roller shutter door manufacturer, I believe you have a certain understanding of it. If you have any questions, welcome to inquire, we will serve you wholeheartedly.